auto sensor signal simulation tool MST-9000 operation question

auto sensor signal simulation tool MST-9000 operation question

Q: I have purchased a MST-9000 and have been trying to use it and screen display has locked up to a solid blue (no text). Initial use was fine, the wakeup with power on to a splash screen, the menu worked and buttons responded. Power on/off a few times and no issue. The SW was loaded to computer (XP OS per instructions) and the SW loaded fine. Drivers for the MST-9000 USB connection were found through connection, manual find and all was OK. An initial waveform was loaded to the ECU software, saved to the disk. After connection of USB from MST-9000 to the computer as stated above the MST-9000 is locked as shown in pictures below. Only the on, off and read buttons have any effect now. The on is on, off is off, out and read beep at me, but read turns on CH1-5. Also the 5V, 12V, and 24V buttons activate lights, gages work too for Volts, etc.

Is there some reset or return to default condition on this MST-9000. I have read the manuals with the CD(PDF’s) but don’t see a way to restart in initial condition. Or a SW setting in the ECU software that allows the reset, etc.